Standard aluminum shapes are the workhorse sections: angles, round, square and rectangular tubes, T and I-beam sections and U-channels held to consistent dimensions so they can be used without custom extrusion tooling. All are produced in 6063-T5 for architectural, framing and general fabrication work, with 6061-T6 available where higher strength or machining is needed, and tolerances to GB/T 5237 or EN 755.
Sizes span small trim sections up to 200 mm sections for structural use, in mill finish and in anodized, powder coated or PVDF finishes for exterior service. We cut to length, miter, notch, drill and tap, so shapes arrive ready to assemble rather than as random stock. Typical uses are railings, sign frames, machine frames, shelving, trailers, solar mounts and general fabrication, with mixed size orders consolidated into one shipment.
6 profiles in Standard Aluminum Shapes
Standard Aluminum Shapes
Extruded aluminum L-angle in equal and unequal leg, supplied in 6063-T5 and 6061-T6 for framing, bracing, brackets and corner…
Standard Aluminum Shapes
Factory-direct extruded aluminum rectangular tubes and flat pipes in 6063 and 6061 alloys, with tailored wall thicknesses…
Standard Aluminum Shapes
Extruded aluminum round tube for structural framing, handrails, marine hardware, heat exchangers and hydraulic lines, supplied in…
Standard Aluminum Shapes
Aluminum square and rectangular tube selection with a practical load-span guide, bending limits and machining data, supplied cut…
Standard Aluminum Shapes
Custom extruded aluminum I-beam and T-profile sections for truck bodies, trailers, machine frames, partition walls, ceiling grids…
Standard Aluminum Shapes
Extruded aluminum U-channel engineered for glass retention, panel systems, sliding tracks and edge protection, with slot…
