Angle Profiles

Angle aluminum profiles are produced in equal and unequal leg sections from 12x12 mm up to 100x100 mm, with leg thickness from 1.2 mm to 10 mm, in 6063-T5 for general fabrication and 6061-T6 for structural brackets and frames. Standard 90 degree angles carry inside fillets sized to the wall, and sharp or radiused outside corners are available depending on the application.

Angles are supplied in mill finish, clear or bronze anodizing and powder coating, cut to length with square or mitered ends and drilled or punched to your hole pattern. They are commonly used for framing, trim, corner reinforcement, solar and sign structures and trailer construction, where a light, corrosion-resistant edge member is needed at low cost.